his is how I solved this issue: Go to run, type gpedit.msc Navigate to Computer Configurations--Administrative Templates--Windows Components--Windows Update In the right hand window select 'Configure Automatic Updates' -- Set it to…
We had a issue uploading larger files (100mb>) to our Synology NAS. After looking in the acces logs on the reverse proxy i found the next errors. a client request…
Replacing a failed disk in a 3PAR is pretty simple you just need to follow a few steps to make sure you do it safely. If you are new to 3PAR or would like to learn more a good place to start is our 3PAR beginners guide
f you are running a HP 3PAR storage array you want to be certain it’s in a healthy state at all times. While you could look through all of the management menus to check the status of components it’s far easier to leverage the checkhealth command.
While working with 3Par storage systems, occasionally it has been important to know how to reset the unit back to pre-MOB(Moment-of-Birth). This information is not readily available in online documentation. For those that are struggling to find that information, here is the procedure.
$servername=read-hostprompt"Enter servername or enclosure , Bay" get-hpovserver-name'$servername'|get-hpovalert-alertstateactive|set-hpovalert-Cleared
To access the CLI, SSH to the IPv4 address of the Virtual Connect SE 40GB F8 interconnect module and log in with default username/password - netop/netoppwd. The IPv4 address of…
Preparing a USB flash drive for reimaging an Synergy Composer appliance
IMPORTANT: Hewlett Packard Enterprise recommends that you prepare a USB flash drive immediately after installing and after updating the appliance firmware so that you always have a USB flash drive that matches the currently installed version of the appliance image. For environments with multiple versions, create separate USB drives, one for each version.
The recommended method to install the OpenVPN Access Server is to use the official OpenVPN Access Server software repository. You will need to be logged on to your Linux system either on the console or via SSH, and have root privileges. Then copy and paste the commands below to add the repository to your system, and install the OpenVPN Access Server client bundle and the OpenVPN Access Server package itself. Installing the package ‘openvpn-as’ will automatically pull in the required client bundle as well.